![]() ![]() ![]() We are going to pick a day and say from this day forward we are all upgraded to autocad 2016 and we are all utilizing company wide drawing standards. A new drawing will not be a problem, but we use many old drawings as templates to modify for new parts. I'm confident that I can find a way to do this and be fairly efficient at it, but the easier it is the more likely my co-workers will do it. I then do a standards check (which is also new to me but Im working on it) to replace the old with the new standards. When I open an old drawing in our new autocad environment and purge it, most of the old stuff goes away and the new stuff nested in the block is being used so it is not purged. Many of our old drawings are cluttered with un-used layers, text and dimension styles. ![]() Through the advise of another user I created a block that contains these layers and styles and nested that block inside of our company logo on the layout sheet. I do have a good template with standard layers and text styles. The link below was messing around with getting the file types with lisps. This is a bit out of my range but it could be a possiblility to give the lisp a if statement to only activate when it hits an older file type. Finnally you can figure out a way to not activate the lisp unless it meets conditions that will omit when it will have potential problems.If you update your old files in batches you can always add the lisp to the start up suite and remove it when done.I am honestly not too familiar with the purge command but judging from other posters I would advise against loading this lisp by default for everyone. This dose a pretty good job at explaining how to put lisps into the start up suite.īefore you start this though whatever code you choose copy and paste the code into notepad and save it as a "anything.lsp" ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |